Announcement

Collapse
No announcement yet.

USB become unrecognizable after 4 passed is done and restart into Window 10 ..

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Origene55
    replied
    Done testing with my new 2 x 8GB DDR3 1600Mhz & it's error free, looks like ram did get "old" over time for whatever reason. So it's time to retire my 4GB ram. Thanks for your time. Have a nice everyday.

    Leave a comment:


  • Origene55
    replied
    I already order 2 x 8GB Kingston DDR3 1600MHz so let's see how it play out once i have it install. Let's hope it pass the test without any error even in dual mode.

    Leave a comment:


  • David (PassMark)
    replied
    Could also be timing, voltage and BIOS firmware issues.

    For the RAM errors see this page.
    https://www.memtest86.com/troubleshooting.htm

    Leave a comment:


  • Origene55
    replied
    So the sticks still consider faulty even if they have errors only in dual channel mode ?? Thanks

    Leave a comment:


  • David (PassMark)
    replied
    Some errors only happen in dual channel mode.
    Correct, RAM does not slow down.
    But nothing lasts forever.

    Leave a comment:


  • Origene55
    replied
    I using 2 x Kingston 4GB DDR3 1333 stick & i having this "get errors only when testing RAM modules together, and not when individually tested" issue, these sticks are 8 yrs old but ram does not slow down over time right ?? Thanks

    Leave a comment:


  • David (PassMark)
    replied
    That the range of memory addresses where the error(s) were encountered. As they are the same number (when rounded to the nearest MB) it means the fault is very localised.

    Leave a comment:


  • Origene55
    replied
    Alright but i can't find the explanation on that page about what i looking for :

    What is this (Lowest error address = 7129mb & Highest error address = 7129mb) mean ??

    Thanks

    Leave a comment:


  • David (PassMark)
    replied
    Maybe your flash drive (hardware) is bad? Try a different flash drive.

    For the RAM errors see this page.
    https://www.memtest86.com/troubleshooting.htm

    Leave a comment:


  • USB become unrecognizable after 4 passed is done and restart into Window 10 ..

    2 times in a row but same thing happen .. after the test is done the USB stick become unrecognizable when i boot back in Windows 10 .. it didn't show up in windows explorer & "Safely remove Hardware & Eject Media" either. I had to delete & repartition using Minitool Partition Wizard to make it detect by Windows again. How so & whats the solution ??

    By the way i had 6 errors after 4 passed. Is the ram still usable or it's time to get a new one ??

    Thanks
Working...
X