Hello,
When i try to run BIT using the commandline using the -R switch to start an automated burn run, the temperature reading does not show on the logfile.
I'm also using the -C switch to use a config file which sets temperature settings to monitor using speedfan (checked manually by loading the cfg file in BIT and checking that speedfan was marked).
Speedfan is running ok.
When I run a manual burn using the start button, temps are reading fine on the main screen and also appear on the logfile.
Am I doing something wrong?
Thanks
Nico
When i try to run BIT using the commandline using the -R switch to start an automated burn run, the temperature reading does not show on the logfile.
I'm also using the -C switch to use a config file which sets temperature settings to monitor using speedfan (checked manually by loading the cfg file in BIT and checking that speedfan was marked).
Speedfan is running ok.
When I run a manual burn using the start button, temps are reading fine on the main screen and also appear on the logfile.
Am I doing something wrong?
Thanks
Nico
Comment