PD Tester Pro with non-PD devices?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • hogwash
    Junior Member
    • Nov 2026
    • 2

    #1

    PD Tester Pro with non-PD devices?

    Hello,

    in addition to the PD equipment I test, I would also like to do a baseline test for "dumb" USB port regulators. it seems like the PDT pro will only apply a load to the equipment if it can first negotiate a power level. However, I would like to be able to test ports for, say 500mA baseline current, even if they are a "dumb" port that does not negotiate. is that possible?

    Thanks
  • Nik (PassMark)
    Employee
    • Jul 2022
    • 18

    #2
    Hello,

    We designed the USB Power Delivery Tester PRO to support testing of the base Type-C specification and this includes testing "dumb" USB ports that do not support the USB Power Delivery Specification. Testing "dumb" USB ports works in exactly the same way as any other Device Under Test and you will face no issues with this. To give a little more information about how the negotiation process works in this case:

    A power sourcing USB-C port will initially attach a pull-up resistor to the CC wire and apply 0V on the VBUS wire. A power consuming USB-C device (such as the USB Power Delivery Tester PRO) puts a pull-down resistor on the CC wire. This CC wire is used to sense when a connection is made, and after the connection is made the power source applies 5V on VBUS.

    If a power sourcing USB-C port supports USB Power Delivery Protocol, then it will start sending messages after the 5V is applied, and negotiate a Power Delivery profile which allows for other voltages to be selected. If it doesn't support USB Power Delivery, then the USB Power Delivery Tester PRO will detect that it does not support it and complete the initial connection process here.

    If you are testing a USB-A port, then all USB-A to USB-C cable will come with a pull-up resistor inside of it that connects the CC wire to the VBUS wire, so there is no issue here either.

    This process with the CC wire is how every device with a Type-C port negotiates the initial power level, and is also how a connection is detected so that the device knows when it is safe to start applying a load.

    Comment

    • hogwash
      Junior Member
      • Nov 2026
      • 2

      #3
      Thanks for the information. the host unit-under-test has a USB-C connector but when I plug in the PDT-Pro, it cannot apply/adjust a load. I can see the host's voltage (~5V) but I cannot apply a load. can you explain why that might happen? if I unplug the cable from the unit under test and plug it into the loopback test port, I can adjust the load.

      Comment

      Working...