Tweet
Hi!
I might not articulate this clearly.... So we do our BurnInPro testing by loading a WinPE environment from a WIM on our network. The WinPE environment has BITpro files and drivers that get run from a test script. Said test script was developed a few years ago using an older set USB 3.0 loopback testers, running under the driver revision 1.2.2.00, using an older version of BurnInTestPro (8.2, maybe 8.4?).
We were to install on these older 3.0 loopback drivers just fine, however we would constantly have an issue of the BurnInTest software being unable to initiate a test with the testers. It would see the devices, get data like the SN, device name, etc, but would frequently fail to initiate test. We recently updated to 9.0 and this has smoothed out a bit of the issues, but we are still encountering the issue intermittently. Note that we never had this issue with the USB 2.0 testers.
I purchased a pair of 2 new 3.0 loopback testers and have been trying to test out running BurnInPro (9.0) with them (hoping to address this issue), however we have been unable to get the new drivers to successfully install with our WinPE environment. The installation script keeps returning an error about being unable to load the cyusb3.inf file in the 3.0 driver directory, with <Error 0x80070002> being returned.
Do you happen to have any insight as to how I can troubleshoot the driver installation?
I might not articulate this clearly.... So we do our BurnInPro testing by loading a WinPE environment from a WIM on our network. The WinPE environment has BITpro files and drivers that get run from a test script. Said test script was developed a few years ago using an older set USB 3.0 loopback testers, running under the driver revision 1.2.2.00, using an older version of BurnInTestPro (8.2, maybe 8.4?).
We were to install on these older 3.0 loopback drivers just fine, however we would constantly have an issue of the BurnInTest software being unable to initiate a test with the testers. It would see the devices, get data like the SN, device name, etc, but would frequently fail to initiate test. We recently updated to 9.0 and this has smoothed out a bit of the issues, but we are still encountering the issue intermittently. Note that we never had this issue with the USB 2.0 testers.
I purchased a pair of 2 new 3.0 loopback testers and have been trying to test out running BurnInPro (9.0) with them (hoping to address this issue), however we have been unable to get the new drivers to successfully install with our WinPE environment. The installation script keeps returning an error about being unable to load the cyusb3.inf file in the 3.0 driver directory, with <Error 0x80070002> being returned.
Do you happen to have any insight as to how I can troubleshoot the driver installation?
Comment